Kia Rio: Rear Disc Brake

Installation

1. Installation is the reverse of removal. 2. Use a SST (09581-11000) when installing the brake caliper assembly. 3 ...

Components

1. Guide rod bolt 2. Bleed screw 3. Caliper carrier 4. Caliper body 5. Brake pad 6. Pad retainer ...

See also:

Hazard Lamp Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or trim remover, remove the hazard lamp switch (A). ...

Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these sig ...

Coolant: Refilling And Bleeding
   Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...