Kia Rio: Rear Washer Motor Inspection
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Remove the front bumper cover. (Refer to the Body group- Front
bumper)
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
1. Front washer (+)
2. Ground
3. Rear washer (-)
|
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
See also:
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition
timing by using these sig ...
Components Location
1. Sub frame
2. Drive shaft
3. Lower arm
4. Strut assembly
5. Steering gearbox
6. Stabilizer bar
...
Rear combination lamp Installation
Rear combination lamp (Inside)
[4 Door]
1.
Install the rear combination lamp assembly.
2.
Connect the rear combination connecto ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026