Kia Rio: Removal - DC DC Converter - Charging System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

1.
Disconnect the battery negative terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the DC/DC converter conector (A).
4.
Remove the DC/DC converter (B) after removing nuts.


Circuit Diagram
...

Installation
1. Install in the reverse order of removal.    • ...

See also:

Blower Unit Components
1. Blower Motor 2. Blower Fan 3. Clamp 4. NVH Pad 5. Connection Case 6. Cluster Ionizer (FATC only) 7. Intake Case (Left) 8. Intake Seal 9. NVH Pad 10. Intake ...

Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these sig ...

Antenna Coil Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") ...

Copyright © www.kirmanual.com 2014-2020