Kia Rio Manuals

Kia Rio: Removal - Rear Drum Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
•
Avoid breathing dust particles.
•
Never use an air hose or brush to clean brake assemblies.
1.
Release the parking brake.
2.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
3.
Remove the rear brake drum (A).
4.
Remove the upper return spring (A).
5.
Remove the lower return spring (B).


6.
Remove the shoe hold springs (A) and shoe hold pins (B) and then remove brake shoe (C). Make sure not to damage the dust cover on the wheel cylinder.
7.
Remove the parking brake cable (A) and then remove brake shoe (B).
8.
Disconnect brake tubes (A) from the wheel cylinder (B).


9.
Remove the bolt (C) and the wheel cylinder (B) from the backing plate (D).
Components
1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spring ...

Installation
   • Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid doe ...

See also:

Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)    ...

Transaxle Control Module (TCM) connector and terminal function
...

Tire pressure monitoring system
(1) Low tire pressure telltale / TPMS malfunction indicator Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by ...

Categories

Copyright www.kirmanual.com 2014-2026