Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Rear Coil Spring Replacement
1.
Remove the rear wheel & tire.
(Both RH side and LH side)
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...
Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat a ...
Audio Unit Components
Terminal specification(PA30A)
No
Terminal Description
Condition
Specified Condition
A1
Loudspeaker Rear Left+
Needed connection to the ca ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026