Kia Rio: Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.

Measure the output voltage of the MAPS at idle and IG ON.

Specification: Refer to "Specification"

Circuit Diagram

(M/T) (A/T) ...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor connecto ...

See also:

Hazard Lamp Switch Installation
1. Connect the connectors. 2. Install the hazard lamp switch. 3. Connect the negative (-) battery terminal. ...

Measurement Method
Projected Dimensions 1. These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions ...

Operation
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of below items; - Fill vent valve - ...

Categories

Copyright © www.kirmanual.com 2014-2026