1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the power window switch module connector (A) from the
wiring harness.
|
4. |
Remove the power window switch module (A) from the door trim after
loosening the mounting screws (5EA).
|
Installation
1.
Install in the reverse order of removal.
Battery (-)terminal installation
[with battery sensor] :
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...
TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Starter: Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...