Kia Rio: Hands free switch Removal - Hands free switch Schematic Diagrams - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Hands free switch Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group - "DAB and Clock spring")
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Remove 2 screws on the steering wheel.


5.
Remove the steering wheel cover (A) after loosening 6 screws.


6.
Remove the hands free switch.
Hands free switch Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. Audio + Bluetooth [LH] ...

Hands free switch Installation
1. Reassemble the hands free switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reasse ...

See also:

Specification
Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 101.3 (1.03, 14.7) 4 ...

Climate control air filter
Filter inspection The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a ...

Troubleshooting
Ignition System Symptom Suspect Area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch Inspect igni ...

Copyright www.kirmanual.com 2014-2026