Kia Rio: Hands free switch Inspection - Hands free switch Schematic Diagrams - Body Electrical System - Kia Rio UB 2012-2019 Service ManualKia Rio: Hands free switch Inspection

1.
Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position.
Audio + Bluetooth [LH]


Switch
Connetor terminal
Resistance (±5%)
End of call
6-8
18.91 kΩ
Send
6-8
40.91 kΩ

Cruise + Voice + Limit [RH]/ Cruise + Voice [RH]


Switch
Connetor terminal
Resistance (±5%)
Voice
3-4
10.71 kΩ

Bluetooth [Lower]


Switch
Connetor terminal
Resistance (±5%)
End of call
5-6
18.91 kΩ
Send
5-6
40.91 kΩ

Hands free switch Schematic Diagrams
Circuit Diagram(1) Circuit Diagram(2) ...

Hands free switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

See also:

Antenna Coil Installation
1. Install the antenna coil. 2. Connect the antenna coil connector. 3. Install the crash pad lower panel. ...

Instrument panel overview
1. Instrument cluster 2. Horn 3. Driver’s front air bag 4. Light control/Turn signals 5. Wiper/Washer 6. Ignition switch or ENGINE START/ STOP button 7. Hazard warning flasher switch 8. Audio ...

Measurement Method
Projected Dimensions 1. These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions ...

Copyright © www.kirmanual.com 2014-2019