Kia Rio: Ignition Switch Assembly Inspection

1.	Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column.

2.	Check for continuity between the terminals.

3.	If continuity is not specified, replace the switch.

Start/Stop Button Installation

1. Install the start/stop button. 2. Install the Audio. ...

Ignition Switch Assembly Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to the ST group - & ...

See also:

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective ECM or when providing additional keys to the vehicle owner. The procedure st ...

Special Service Tools
Tool(Number and Name) Illustration Use Deployment tool 0957A-34100A Airbag deployment tool. Deployment adapter 0957A-3Q100 ...

Component Location Index
Engine Room 1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Assembly 7. Service ...

Categories

Copyright © www.kirmanual.com 2014-2025