Kia Rio Manuals

Kia Rio: Compressor Oil Specification - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: Compressor Oil Specification

1.
The HFC-134a system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.
2.
Compressor oil (PAG) varies according to compressor model. Be sure to use oil specified for the model of compressor.
Handling of Oil
1.
The oil should be free from moisture, dust, metal powder, etc.
2.
Do not mix with other oil.
3.
The water content in the oil increases when exposed to the air. After use, seal oil from air immediately. (HFC-134a compressor oil absorbs moisture very easily.)
4.
The compressor oil must be stored in steel containers, not in plastic containers.
Compressor Oil Check
The oil used to lubricate the compressor is circulating with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system
PAG OIL : 120 ± 10 cc
Oil Return Operation
There is close affinity between the oil and the refrigerant.
During normal operation, part of the oil recirculation with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must be run in advance for oil return operation. The procedure is as follows :
1.
Open all the doors and the engine hood.
2.
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.
3.
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.
4.
Stop the engine.
Interior
1. Auto Defogging Sensor 2. Photo Sensor 3. Heater & A/C controller (MANUAL) 4. Heater & A/C controller (FATC) 5. In-car Sensor 6. Heater & Blower Unit 7. ...

Refrigerant line Replacement
1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose.    ...

See also:

Description of ESC
Electronic Stability Control (ESC) recognizes critical driving conditions, such as panic reactions in dangerous situations, and stabilizes the vehicle by wheel-individual braking and engine c ...

Output Speed Sensor Specifications
▷ Type: Hall effect sensor Operation condition [°C(°F)] ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (0.85 ~ 1.3) 0.0335 ~ 0.0512 Output vo ...

A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) convert the pressure value of high pressure line into voltage value after measure it. By converted voltage value, engine ECU controls cooling fan by operatin ...

Categories

Copyright www.kirmanual.com 2014-2026