Kia Rio: Blower Resistor (MANUAL) Inspection

Blower Motor Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad and heater & blower unit assembly. (Refer to HA group – â ...

Blower Resistor (MANUAL) Replacement

1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

See also:

Installation
   • Install the component with the specified torques. • ...

Compressor Inspection
1. Check the plated parts of the disc & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the clutch set. ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...