Kia Rio: Heater & A/C Control Unit (FATC) Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the heater & A/C controller (A) from the center facia using a flat-head screwdriver or remover.

3.	Disconnect the connectors (A) and the air hose (B).

4.	Install in the reverse order of removal.

Heater & A/C Control Unit (FATC) Self Diagnosis

1. Self-diagnosis process 2. How to read self-diagnostic code During the self-diagnosis, the corresponding fault code flickers ...

See also:

Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat a ...

Audio Remote Control Inspection
1. Check the audio remote control switch (A) for resistance between No.5 and No.7 terminals in each switch position. Switch Connect ...

Line Pressure Control Solenoid Valve Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Categories

Copyright © www.kirmanual.com 2014-2026