Kia Rio Manuals

Kia Rio: Preparation Of Tools And Measuring Equipment - General Information - Kia Rio UB 2012-2026 Service ManualKia Rio: Preparation Of Tools And Measuring Equipment

Be sure that all necessary tools and measuring equipment are available starting work.
Special Tools
Use special tools when they are required.

Removal Of Parts


Removal Of Parts
First find the cause of the problem and then determine whether removal or disassembly before starting the job.

Disassembly


Disassembly
If the disassembly procedure is complex, requiring many parts to be disassembled, all parts should be disassembled in a way that will not affect their performance or external appearance.
1.
Inspection of parts
Each part, when removed, should be carefully on suspected for malfunction, deformation, damage, and other problems.
2.
Arrangement of parts
All disassembled parts should be carefully arranged for effective reassembly.
Be sure to separate and correctly identify the parts to be replaced from those that will be used again.
3.
Cleaning parts for reuse
All parts to be used again should be carefully and thoroughly cleaned by an appropriate method.
Parts
When replacing parts, use KIA MOTORS genuine parts.

Replacement


Replacement
Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced with new ones.
1.
Oil seals
2.
Gaskets
3.
O-rings
4.
Lock washers
5.
Cotter pins (split pins)
6.
Plastic nuts


Depending on their location.
7.
Sealant should be applied to gaskets.
8.
Oil should be applied to the moving components of parts.
9.
Specified oil or grease should be applied to the prescribed locations (oil seals, etc) before assembly.
Adjustment
Use gauges and testers to adjust correctly the parts to standard values correctly.
General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.    The s ...

Electrical System
1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting con ...

See also:

5Door Rear Body
Side outer panel rear corner Tail gate hinge mounting hole (Ø14) Tail gate hinge mounting hole (Ø1 ...

Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted wh ...

Electric power steering
Power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require i ...

Categories

Copyright www.kirmanual.com 2014-2026