Kia Rio Manuals

Kia Rio: Thermostat: Installation - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Thermostat: Installation

1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).
Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)


3.
Fill with engine coolant.
4.
Start engine and check for leaks.
Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...

Thermostat: Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting ...

See also:

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

Back-up Lamp Switch Replacement
1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(&# ...

Categories

Copyright www.kirmanual.com 2014-2026