Kia Rio: Engine Oil: Oil And Filter Replacement
| •
|
Prolonged and repeated contact with mineral oil will result
in the removal of natural fats from the skin, leading to dryness,
irritation and dermatitis. In addition, used engine oil contains
potentially harmful contaminants which may cause skin cancer.
|
| •
|
Exercise caution in order to minimize the length and frequency
of contact of your skin to used oil. Wear protective clothing
and gloves. Wash your skin thoroughly with soap and water, or
use water-less hand cleaner, to remove any used engine oil.
Do not use gasoline, thinners, or solvents.
|
| •
|
In order to preserve the environment, used oil and used
oil filter must be disposed of only at designated disposal sites.
|
|
|
1. |
Drain the engine oil.
|
(1) |
Remove the oil filler cap.
|
|
(2) |
Remove the oil drain plug, and drain the oil into a container.
|
|
|
2. |
Replace the oil filter.
|
(1) |
Remove the oil filter.
|
|
(2) |
Check and clean the oil filter installation surface.
|
|
(3) |
Check the part number of the new oil filter is as same
as old one.
|
|
(4) |
Apply clean engine oil to the gasket of a new oil filter.
|
|
(5) |
Lightly screw the oil filter into place, and tighten it
until the gasket contacts the seat.
|
|
(6) |
Tighten it with the torque below.
Tightening torque :
11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)
|
|
|
|
3. |
Refill with engine oil.
|
(1) |
Clean and install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
|
|
|
(2) |
Fill with fresh engine oil.
Capacity
Total : 4.0L (4.22US qt, 3.51lmp qt)
Oil pan : 3.3L (3.48US qt, 2.90lmp qt)
Drain and refill in cluding oil filter :
3.6L (3.80US qt, 3.16lmp qt)
|
|
|
(3) |
Install the oil filler cap.
|
|
|
4. |
Start engine and check for oil leaks.
|
|
5. |
Recheck the engine oil level.
|
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
See also:
Circuit Diagram
(M/T)
(A/T)
...
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Manifold Catalytic Converter. The sensor
output voltage varies in accordance ...
Muffler: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
Without battery sensor :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...
Engine Oil: Oil And Filter Replacement
Engine Oil: Inspection