Kia Rio: Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Circuit Diagram
(M/T)
(A/T)
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to ...
See also:
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, or the airba ...
Function
Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1.
Keyless entry function is performed in a state that key in switch
is eliminated f ...
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026