Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Installation is reverse of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
See also:
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...
Valve Clearance Inspection And Adjustment
Inspect and adjust the valve clearance when the engine is cold
(Engine coolant temperature : 20°C) and cylinder head is ...
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
Removal
