Kia Rio: Removal - Crankshaft Position Sensor (CKPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.


Inspection
1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” ...

Installation
   • Install the component with the specified torques. • ...

See also:

26 Brake Control Solenoid Valve(26/B_VFS) Description
26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

Room Lamp Inspection
Room Lamp Remove the room lamp assembly then check for continuity between terminal. If the continuity is not as specified, replace the room lamp assemlby. ...

Flat tire
Jack and tools The spare tire, jack, jack handle and wheel lug nut wrench are stored in the luggage compartment. Remove the luggage under tray out of the way to reach the equipment. (1) Jack ha ...

Copyright www.kirmanual.com 2014-2026