Kia Rio: Inspection - Crankshaft Position Sensor (CKPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2019 Service ManualKia Rio: Inspection

1.
Check signal waveform of CKPS and CMPS using a GDS.

Specification: Refer to “Waveform”

Circuit Diagram
(M/T) (A/T) ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) ...

See also:

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV termina ...

Antenna Inspection
Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. ...

Copyright © www.kirmanual.com 2014-2019