Kia Rio: Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.

Measure the output voltage of the RPS at idle and various engine speed.

Condition	Output Voltage (V)
Idle	Approx. 1.2
1,500 rpm	2.2 ~ 2.5
6,300 rpm	Approx. 3.0

Circuit Diagram

(M/T) (A/T) ...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...

See also:

Oil Pressure Switch: Inspection
1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. ...

Removal
1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the evaporator temperature sensor connector (A). 3. ...

Categories

Copyright © www.kirmanual.com 2014-2026