Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the rear seat (Refer to "Seat" in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel tank pressure sensor connector.
|
| 5. |
Remove the fuel tank pressure sensor (A) after releasing the hooks
vertically.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the ...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...
Troubleshooting
Symptom
Suspect area
Engine will not start or hard to start
Vapor hose damaged or disconnected
Engine struggles to start
Malfunction of the Pu ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026