Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
|
1. |
Installation is reverse of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD gro ...
See also:
Photo Sensor (FATC only) Description
The photo sensor is located at the center of defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving port ...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic compressor oil (PAG) whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
Installation
1.
Dowel pin of crankshaft setted about 3° with vertical center line.
2.
Align the TDC marks (A) of the CVVT sprockets with the upper s ...
Removal
Injector