Kia Rio Manuals

Kia Rio: Removal - Canister Close Valve (CCV) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the fuel tank air filter assembly after removing a bolt (A).
6.
Remove the bracket (A) after pulling it.
7.
Release the lever (A) by lifting it up.
8.
Remove the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.
Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

Installation
   • Install the component with the specified torques. • ...

See also:

Troubleshooting
Vehicle inspection SYMPTOM CHART Symptom Suspect Area Remedy (See page) Squeak or grunt-noise from the front suspension, occurs more in cold ambient t ...

Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

Categories

Copyright www.kirmanual.com 2014-2026