Opu Connector Terminal Function |
EGGG114-A |
EGGG114-B |
||
Pin No. |
Description |
Pin No. |
Description |
1 |
Motor power(W) |
1 |
CAN communication (High) |
2 |
Motor power(V) |
2 |
CAN communication (Low) |
3 |
Hall sensor(Ground) |
3 |
- |
4 |
Ground |
4 |
- |
5 |
Motor power(U) |
5 |
- |
6 |
Shield ground |
6 |
- |
7 |
Hall sensor signal input (W) |
7 |
- |
8 |
Hall sensor signal input (V) |
8 |
- |
9 |
Hall sensor signal input (U) |
9 |
Ignition ON / Start |
10 |
Hall sensor power |
10 |
- |
11 |
Battery voltage |
|
|
Wipers & Washers
A : Wiper speed control (front)
HI – High wiper speed
LO – Low wiper speed
INT – Intermittent wipe
AUTO– Automatic control wipe
OFF – Off
MIST – Single wipe
B : Intermittent control ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Anchor Pretensioner (APT) Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...