Kia Rio: Filler-Neck Assembly Removal
| 1. |
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
|
| 2. |
Disconnect the fuel filler hose (A) and the vapor hose (B).
|
| 3. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting bolt (A).
|
Fuel Filter Replacement
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...
Filler-Neck Assembly Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket
installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
See also:
Disassembly
1.
Remove the rear cover (A) after removing nuts.
2.
Remove the mounting bolts (A) and the brush holder assembly (B).
...
Installation
1.
Dowel pin of crankshaft setted about 3° with vertical center line.
2.
Align the TDC marks (A) of the CVVT sprockets with the upper su ...
Installation
1.
Install the back view camera.
2.
Install the tailgate trim.
...
Copyright © www.kirmanual.com 2014-2024