Kia Rio Manuals

Kia Rio: Removal - Clutch Master Cylinder - Clutch System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the push rod (B) from the clutch pedal by removing the snap pin (A) and washer.
2.
Remove the clutch pedal mounting nuts (B-3ea).
Tightening torque:
12.7 ~ 15.7 Nm (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)


3.
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
4.
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.


5.
Remove the clutch master cylinder by turning it clockwise (A).
Components
1. Master cylinder 2. Ignition lock switch 3. Clutch switch 4. Pedal pad ...

Installation
1. Installation is the reverse of removal.    • ...

See also:

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Inspection
1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” ...

SRS Control Module (SRSCM) Description
The primary purpose of the Supplemental Restraints System Control Module (SRSCM) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

Categories

Copyright www.kirmanual.com 2014-2026