1. |
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
|
2. |
Disconnect select adjuster (A) to an arrow.
|
3. |
Shift to the 3th gear position.
|
4. |
Adjustment adjuster (B) on select cable (A) as rolling from side
to side.
|
5. |
Insert on free load and press the adjuster.
|
6. |
After shifting 2nd gear, cheking the left select gap about 1mm(if
not, loop no, 1~5)
|
7. |
In neutral position, jion by clip (A).
|
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
...
Ignition Switch Assembly Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Torque Converter Control Solenoid Valve (T/CON_VFS) Installation
1.
Installation is the reverse of removal.
•
...