Kia Rio: Back-up Lamp Switch Replacement - Manual Transaxle Components - Manual Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Back-up Lamp Switch Replacement

1.
Disconnect the back up lamp switch connector (A).


2.
Remove the back up lamp switch (A).


3.
Replace a new one and install the back up lamp switch.

Tightening torque:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Back-up Lamp Switch Inspection
1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Automatic Transaxle System
...

See also:

Installation
1. Installation is the reverse of removal.    • ...

Fuel Tank Air Filter
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. ...

Side Airbag (SAB) Module Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Si ...

Copyright www.kirmanual.com 2014-2026