Kia Rio: Oil Pump Components
| 1. Oil pump cover 2. Oil pump housing 3. Driven gear 4. Drive gear 5. Oil seal |
6. Bushing-housing 7. Reaction shaft 8. Bushing-reaction shaft 9. Sleeve 10. Bolt |
Oil Pump Operation Flow
| 1. Inhale(Oil filter) 2. Inhale(Valve body) 3. Outlet 4. 26/B operation pressure |
5. 35R/C operation pressure 6. Lubrication 7. Lock up clutch apply pressure 8. Lock up clutch release pressure |
Oil Pump Description
The oil pump is built-in as a single unit with the 26 brake chamber. Rotation
of the pump builds the hydraulic pressure needed for the lubrication of the
various parts of the transaxle and op ...
Fluid Components Location
1. Injection hole(eyebolt)
2. Oil level plug
3. Oil drain plug
...
See also:
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition
timing by using these sig ...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic compressor oil (PAG) whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
Release Residual Pressure in Fuel Line
Whenever the high pressure fuel pump, fuel pipe, delivery pipe,
or injector is removed immediately after shutting off th ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026