Kia Rio: Valve Body Installation
|
1. |
Installation is the reverse of removal.
|
|
After replacement or reinstallation procedure of the valve body
assembly, must perform procedures below.
|
| •
|
The gasket of the valve body gasket (A) use new one.
|
| •
|
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
|
| •
|
Perform TCM learning after replacing the valve body to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C),
a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake
(UD/B), a 26 brake (26/B), and a 35R clutch ...
See also:
Starter: Components
1. Screw
2. Front housing
3. Stop ring
4. Stopper
5. Overunn clutch
6. Lever
7. Lever plate
8. Lever packing
9. Magnet switch assembly
10. Armature assemb ...
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Ignition Coil: Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connec ...
Valve Body Removal
Clutch & Brake