Kia Rio: TJ Joint Inspection

TJ Joint Replacement

   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

TJ Joint Installation

1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

See also:

ESC Control Module Removal
1. Turn ignition switch OFF. 2. Pull up the lock of the HECU connector (A), and then disconnect the connector. ...

Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Blower Unit Replacement
1. Remove the heater & blower unit. (Refer to HA group - "Heater Unit") 2. Separate the blower unit from the heater unit a ...