Kia Rio: Hazard Lamp Switch Installation

Hazard Lamp Switch Removal

1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or trim remover, remove the hazard lamp switch (A). ...

Hazard Lamp Switch Inspection

1. Operate the switch and check for continuity between terminals. ...

See also:

Steering Gear box Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Rear Washer Switch Inspection
1. With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...

SS-B Solenoid Valve(ON/OFF) Circuit Diagram
...