Kia Rio: Dynamic Damper Installation
| 1. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
|
| 2. |
Install the dynamic damper.
|
| 3. |
Install the dynamic damper band.
|
| 4. |
Using the SST(09495-3K000), secure the TJ boot bands (A).
|
| 5. |
Install the TJ joint assembly. (Refer to DS group - “TJ joint”)
|
| 6. |
Install the front driveshaft. (Refer to DS group - “Front Driveshaft”)
|
Dynamic Damper Replacement
1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint ...
BJ Boot Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
See also:
Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
...
Driving your vehicle
Be sure the exhaust system does not leak.
The exhaust system should be checked whenever the vehicle is raised to change
the oil or for any other purpose. If you hear a change in the sound of the ex ...
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, or the airba ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026