1. |
Check the bushing for wear and deterioration.
|
2. |
Check the front stabilizer bar for deformation.
|
3. |
Check the front stabilizer link ball joint for damage.
|
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
Transaxle Oil Temperature Sensor Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Engine Oil: Oil And Filter Replacement
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...