Kia Rio Manuals

Kia Rio: Wheel Hub Nut Tightening Sequence - Tires/Wheels - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: Wheel Hub Nut Tightening Sequence

Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)



     
•
When using an impact gun, final tightening torque should be checked using a torque wrench.
•
A wheel that is not the correct size may adversely affect wheel and bearing life, braking and stopping abilities, handling characteristics, ground clearance, body-to-tire clearance, snow chain clearance, speedometer and odometer calibration, headlight aim and bumper height.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Run-out
 Aluminum
 Steel
Radial mm(in.)
 Below 0.3(0.012)
 Below 1.4(0.055)
Lateral mm(in.)
 Below 0.3(0.012)
 Below 0.9(0.035)

3.
If measured value exceeds the standard value, replace the wheel.
Rear Wheel Alignment
   When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always p ...

Tire Wear
   • Using tires and wheel other than the recommended sizes could cause unusual handling ...

See also:

Fuel filler lid
Opening the fuel filler lid The fuel filler lid must be opened from inside the vehicle by pulling up the fuel filler lid opener. If the fuel filler lid does not open because ice has formed aroun ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TP ...

Circuit Diagram
(M/T) (A/T) ...

Categories

Copyright www.kirmanual.com 2014-2026