Kia Rio Manuals

Kia Rio: TPMS Sensor Replacement - Tire Pressure Monitoring System - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: TPMS Sensor Replacement

Repair tire after using the Tire Mobility Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.

     
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.


3.
Install the TPMS sensor to the new tire.
4.
Check that the normal operation of TPMS system.
When the TPMS warning lamp ON
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.

     
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.


3.
Install the TPMS sensor to the new tire.
4.
Check the tire pressure using the electrical tire pressure gauge.
5.
Check the tire pressure of TPMS sensor using the GDS
6.
If the difference between two checked pressures in the above is not more than 2 psi, TPMS sensor is normal. Reinstall it to new tire.
7.
If the difference between two checked pressures in the above is more than 2 psi, TPMS sensor is abnormal. Install new TPMS sensor to new tire.
8.
Check that the normal operation of TPMS system.
TPMS Sensor Removal
   Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

TPMS Sensor Installation
Sensor Fit    • Handle the sensor with care. • ...

See also:

Photo Sensor (FATC only) Description
The photo sensor is located at the center of defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving port ...

Rear Torsion Beam Axle Replacement
[Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

4Door Under Body
Projected Dimensions Front side member tooling hole (Ø6.6) Front side member tooling hole (Ø6.6) ...

Categories

Copyright www.kirmanual.com 2014-2026