Kia Rio Manuals

Kia Rio: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Impact Sensor (FIS) Removal


     
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front wheel guard.
(Refer to the Body group - "Exterior")
3.
Left side - Remove the air duct assembly.
Right side - Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
4.
Remove the front impact sensor (B) mounting bolt.
5.
Disconnect the front impact sensor connector (A).
6.
Remove the front impact sensor.
Front Impact Sensor (FIS) Components
...

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

General Information
The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the drive ...

Components
1. Guide rod bolt 2. Bleed screw 3. Caliper body 4. Caliper carrier 5. Inner pad shim 6. Brake pad 7. Pad retainer ...

SS-B Solenoid Valve(ON/OFF) Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Categories

Copyright www.kirmanual.com 2014-2026