Kia Rio: Passenger Airbag (PAB) ModuleInstallation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least thirty seconds before beginning work.
|
| 3. |
Place the passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
| 4. |
Install the heater duct to the crash pad.
|
| 5. |
Install the crash pad.
(Refer to the Body group- "Crash pad")
|
| 6. |
Tighten the passenger airbag crash pad mounting bolt.
|
| 7. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
| 8. |
Reinstall the glove box.
(Refer to the Body group - "Crash pad")
|
| 9. |
Reconnect the battery negative cable.
|
| 10. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Passenger Airbag (PAB) Module Removal
Side Airbag (SAB) Module DescriptionInstallation
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Interior light
Do not use the interior lights for extended periods when the engine is not running.
It may cause battery discharge.
WARNING - Interior light
Do not use the interior lights when driving in the dark. ...
Ending voice recognition
While Voice Recognition is operating
Press and hold
the key on
the steering remote controller (over 0.8 seconds)
While using voice command, pressing any steering wheel control or a differen ...