Kia Rio: Curtain Airbag (CAB) Module Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Tighten the curtain airbag mounting bolts.

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

â€¢	Never twist the airbag module during installation. If the airbag module is twisted, it may not operate as designed.

4.	Connect the curtain airbag connector.

5.	Install the roof trim. (Refer to the Body group- "Interior")

6.	Reconnect the battery negative cable.

After installing the curtain airbag (CAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Curtain Airbag (CAB) Module Removal

1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the roof trim. (Ref ...

Airbag Disposal

Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airbags or side airbag ...

Kia Rio: Curtain Airbag (CAB) Module Installation

Curtain Airbag (CAB) Module Removal

Airbag Disposal

See also:

Categories