Kia Rio Manuals

Kia Rio: Installation - Seat Belt Pretensioner - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the seat belt pretensioner with bolts (B, C).
Tightening torque:
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)


4.
Connect the seat belt pretensioner connector (A).
5.
Install the upper anchor bolt.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
7.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
8.
Insert the seat belt to the anchor pretensioner.

     
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat a ...

See also:

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

Specifications
Items Specifications Clutch operation method Hydraulic type Clutch cover  Type Diaphragm spring strap Clutch disc Ty ...

Disaseembly
1. Loosen the screw(6ea) and remove the lower cover (A) from the steering wheel body. 2. Disconnect the heated steering wheel unit ...

Categories

Copyright www.kirmanual.com 2014-2026