Kia Rio: Anchor Pretensioner (APT) Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the seat belt after pushing the lock pin (A).
|
| 3. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
| 4. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
| 5. |
Disconnect the anchor pretensioner connector (A).
|
| 6. |
Loosen the anchor pretensioner mounting bolt (B) and remove the
anchor pretensioner.
|
Anchor Pretensioner (APT) Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
See also:
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals
of multi-function switch connector.
...
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54)
Current value(mA ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025