Kia Rio: Anchor Pretensioner (APT) Installation

1.	Remove ignition key from the vehicle.

2.	Disconnect the negative (-) cable from battery and wait for at least thirty seconds.

Install the anchor pretensioner with a bolt.

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the anchor pretensioner connector.

5.	Install the center pillar trim. (Refer to the Body group - "Interior trim")

6.	Install the door scuff trim. (Refer to the Body group - "Interior trim")

Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected in properly.

8.	Reconnect the battery negative cable.

After installing the anchor pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

...

Categories