Kia Rio Manuals

Kia Rio: Removal - Brake Line - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.

     
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Loosening the tube flare nut (B).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
[Front]


[Rear]
5.
Disconnect the brake tube by remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).
Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
[Front disc brake]


[Rear Disc brake]
Components
...

Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data ...

Removal
   • Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does ...

Disassembly
Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. M/T : Remove the fly wheel. 2. ...

Categories

Copyright www.kirmanual.com 2014-2026