Kia Rio Manuals

Kia Rio: Removal - Parking Brake System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

Rear Disc Brake Type

     
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.
3.
Loosen the adjusting nut (A) and the parking brake cables (B).



     
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly after removing the bolts (A).
5.
Raise the vehicle, and make sure it is securely supported.
6.
Remove the rear tire and wheel.
7.
Remove the parking brake cable (A), after removing the clip (B).
8.
Loosen the parking brake cable bracket bolts and remove the parking brake cable.
Rear Drum Brake Type

     
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.
3.
Loosen the adjusting nut (A) and the parking brake cables (B).



     
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly after removing the bolts (A).
5.
Raise the vehicle, and make sure it is securely supported.
6.
Remove the rear tire and wheel.
7.
Remove the parking brake cable from the brake shoe. (Refer to the rear drum brake)
8.
Remove the parking brake cable (A), after removing the clip (B).


9.
Loosen the parking brake cable bracket bolts and remove the parking brake cable.
Components
1. Parking brake lever 2. Adjuster cable 3. Equalizer assembly 4. Parking brake cable ...

Installation
Rear Disc Brake Type 1. Install the parking brake cable. 2. Install the parking brake cable (A), and then install the clip (B ...

See also:

Output Speed Sensor Description
The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor provides ...

Components
...

TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Categories

Copyright www.kirmanual.com 2014-2026