Kia Rio: Rear Wheel Speed Sensor Inspection - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Wheel Speed Sensor Inspection

1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

     
•
In order to protect the wheel speed sensor, when measuring output voltage, a 120 Ω resister must be used as shown.


2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.



V_low: 0.7 V ~ 1.0 V
V_high: 1.4 V ~ 2.0 V
Frequency range: 1 ~ 2,500Hz

Rear Wheel Speed Sensor Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Yaw-rate and G Sensor Description
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. If yaw ...

See also:

AVN Head Unit Installation
AVN Head Unit 1. Connect the AVN head unit connectors and cable. 2. Install the AVN head unit. 3. Install t ...

Operation and Leakage Check
Check all of the following items: Component Procedure Brake Booster (A) Check brake operation by applying the brakes during a test drive. If the brak ...

Oil Pump Description
The oil pump is built-in as a single unit with the 26 brake chamber. Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxle and op ...

Copyright © www.kirmanual.com 2014-2026