Kia Rio: Signal Waveform

Specification

HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) ...

Circuit Diagram

(M/T) (A/T) ...

See also:

Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

Brake Booster Vacuum Pressure Sensor: Inspection
1. Check installation status of BBVPS and Vacuum hose or damage of vacuum hose. 2. Connect GDS to DLC (Data Link Cable). ...

Radiator: Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester. 2. Apply ...