- |
Refer to the BE group - inspection / self diagnosis with GDS.
|
- |
Refer to the BE group - inspection / self diagnosis with GDS.
|
- |
Refer to the BE group - inspection / self diagnosis with GDS.
|
1. |
Check for continuity between the Trunk lid open switch terminals.
|
2. |
If continuity is not specified, inspect the switch
|
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect igni ...
Special Service Tools
Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture (Beam)
Removal and installation of the transaxle.
Use t ...
Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side c ...