Kia Rio: Specification - Accelerator Position Sensor (APS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2024 Service ManualKia Rio: Specification

Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35

Circuit Diagram


Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Circuit Diagram
(M/T) (A/T) ...

See also:

Yaw-rate and G Sensor Description
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. If yaw ...

Sunroof Motor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - " Roof trim") ...

Installation
1. Install in the reverse order of removal. Battery (-)terminal installation [with battery sensor] : 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...

Copyright © www.kirmanual.com 2014-2024