Kia Rio: SS-A Solenoid Valve(ON/OFF) Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2020 Service ManualKia Rio: SS-A Solenoid Valve(ON/OFF) Installation

1.
Installation is the reverse of removal.

     
Х
When installing, apply the ATF oil or white vaseline to the O-ring (A) not to be damaged.


Х
The gasket of the valve body gasket (A) use new one.


Х
Adding automatic transaxle fluid.
(Refer to "automatic transaxle system" in this group.)
SS-A Solenoid Valve(ON/OFF) Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

SS-B Solenoid Valve(ON/OFF) Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

See also:

Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Pin Function (Connector A) Pin Function (Connector B) ...

Radiator: Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester. 2. Apply ...

Rear Torsion Beam Axle Replacement
[Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Copyright © www.kirmanual.com 2014-2020